Skip to Content
Skip to content
EUREk · Your local water expert in OutaouaisAuthorized, Independent Kinetico Dealer819 303-0838

EUREk · Understanding your water

Salt bridges, excess water and brine tank overflow

Some water at the bottom of the brine tank is often normal: depending on the model, it holds water all the time or refills before regeneration. Salt that stops going down points to a salt bridge; water rising to the rim or overflowing points to a valve or drain problem.

Updated October 12, 2026

What you see and what it means

What you seeLikely causeWhat to do
Salt level stuck, hard waterSalt bridge (hollow crust)Break the crust gently
Mushy salt at the bottomPoor-quality salt or humidityEmpty and clean the tank
Water near the rimRefill, float or drain issueHave the valve checked
Water on the floorStuck valve or blocked drainBypass the softener, call

How to break a salt bridge safely

Tap the crust gently with a broom handle until it drops, without hitting the walls or the brine well. Then let the softener run a regeneration.

Keeping it from coming back

Fill the tank about halfway rather than to the top, use evaporated salt pellets and avoid very humid rooms. See salt and water consumption.

Frequently asked questions

How much water is normal in a brine tank?

It depends on the model and the point in the cycle. What matters is change: a sudden rise or an overflow needs a check.

Why is my salt level not going down?

Most often a salt bridge has formed: the salt on top sits on a crust and no longer touches the water.

Can I use rock salt or de-icing salt?

No. Its impurities foul the tank and valve. Use salt made for water softeners.

Sources and references
  1. Scale Deposits · Water Quality Association
  2. Water Softeners and Septic Systems · Water Quality Association
  3. Drinking water and health: Treatment · Health Canada

Have your brine tank checked

Send the model, a level photo and the circumstances of the overflow or observed change.

Request a tank check