Signs of iron and manganese
- orange or brown stains (iron) and black specks (manganese) on fixtures and laundry;
- water that comes out clear, then turns rusty after a few minutes;
- metallic taste and buildup in the water heater and appliances.
Only a test tells you the form and level: see iron in well water.
How an iron filter works
Dissolved (ferrous) iron is invisible. Oxidation turns it into ferric iron, which forms particles. The filter traps those particles and sends them to drain during an automatic backwash.
Oxidation methods
- Air injection: an air pocket in the tank oxidizes iron and strips some sulfur, with no chemicals.
- Catalytic media: the media speeds up oxidation and traps the particles.
- Chlorine or peroxide feed, then filtration: for high levels or when hydrogen sulfide is present.
Why manganese is harder
Manganese oxidizes more slowly than iron and often needs a higher pH or a stronger oxidant. A system that handles iron well may not handle manganese: check the manufacturer's limits for both.
What about a softener or a cartridge?
Some softeners handle low levels of dissolved iron, depending on the model. A sediment cartridge only catches iron that is already in particle form. Beyond that, a dedicated filter protects the softener resin and gives stable results.
Choosing by test results
| Your water | Common approach |
|---|---|
| Moderate dissolved iron, normal pH | Air injection or catalytic media |
| Iron and manganese together | Catalytic media, pH checked |
| Iron with a sulfur smell | Air injection or chemical oxidation, then filtration |
| Iron bound to tannins (yellow water) | Specific treatment based on testing |
| Slimy reddish deposits | Iron bacteria: disinfection and follow-up |
Installation and upkeep
The filter goes after sediment filtration and before the softener and UV. Backwashing needs enough pump flow and a drain.
Backwash flow and drainage
The media bed must lift and rinse at every backwash. Low pump flow or a poor drain lets the media foul. See backwash and drainage.
When stains come back
Check the backwash schedule, pump flow, media condition and any change in your well water. See iron filter: stains are returning.
Frequently asked questions
How much iron is too much?
Health Canada sets an aesthetic objective of 0.1 mg/L for iron and 0.02 mg/L for manganese; above these, staining and taste are common. Manganese also has a maximum acceptable concentration of 0.12 mg/L.
Will an iron filter also remove the sulfur smell?
Air injection and chemical oxidation systems can treat iron, manganese and hydrogen sulfide together. Ask which parameters the proposed model is rated for.
Do I need an iron filter before a UV system?
Often, yes. Iron coats the quartz sleeve; the Water Quality Association cites a common target of under 0.3 mg/L before UV.
How long does the media last?
Several years with regular backwashing, depending on the media and water quality. Before-and-after testing tells you when service is needed.
Where we work
Our team installs and services iron and manganese filters at home, in English or French: Gatineau (Aylmer, Hull, Buckingham, Masson-Angers), Chelsea, Wakefield and Luskville, Cantley, Val-des-Monts, Papineau, the Vallée-de-la-Gatineau, the Pontiac, Ottawa and Prescott-Russell.
Sources and references
- Guideline Technical Document: Iron · Health Canada
- Guideline Technical Document: Manganese · Health Canada
- Staining · Water Quality Association
- Treat your well water · Health Canada