Skip to Content
Skip to content
EUREk · Your local water expert in OutaouaisAuthorized, Independent Kinetico Dealer819 303-0838

EUREk · Understanding your water

Backwash flow and drainage for filters and softeners

A tank filter cleans itself by reversing the water flow: that's backwashing. It needs more flow than normal use, which the well must supply and the drain must handle. A weak backwash lets the media clog.

Updated October 12, 2026

Three checks before installing

CheckWhy
Well flow availableThe media has to lift to get clean
Drain capacityBackwash water arrives fast and in volume
Air gapKeeps drain water from flowing back into the unit

When the well can't keep up

On a low-yield well, a media that needs less water or a storage tank makes backwashing possible. See peak flow.

Where the backwash water goes

Floor drain, sump or septic system: the destination is checked against local rules and the system. See softener discharge and septic systems.

Frequently asked questions

How often does a filter backwash?

It depends on the media and water: from every few days to every few weeks, set by the iron or sediment load.

Why does pressure drop during backwash?

Water is being sent to drain, which is why backwash is scheduled overnight.

Does a softener need the same flow?

It also needs a proper drain, but usually a lower backwash flow than a heavy-media filter.

Sources and references
  1. Drinking water and health: Treatment · Health Canada
  2. Water Softeners and Septic Systems · Water Quality Association
  3. Protect and maintain your well · Health Canada

Check your backwash conditions

Share the pump model, treatment equipment and proposed drain location.

Prepare my installation