Skip to Content
Skip to content
EUREk · Your local water expert in OutaouaisAuthorized, Independent Kinetico Dealer819 303-0838
EUREk · Outaouais

Sulfur smell in water: hydrogen sulfide in well water

A rotten-egg or "sulfur" smell in water comes from hydrogen sulfide (H₂S), a dissolved gas common in well water. Health Canada's aesthetic objective is 0.05 mg/L. First, find out whether the smell is in the cold water (the well) or only the hot water (the water heater). Treatment then depends on the measured level, pH and iron.

Adjusting a shower control, Kinetico campaign

Why does my well water smell like rotten eggs?

Three different things get called "sulfur":

  • Hydrogen sulfide (H₂S): a dissolved gas with a rotten-egg odour, noticeable even at very low levels.
  • Sulfate: a dissolved mineral with no smell; at high levels it can have a laxative effect.
  • Sulfate-reducing bacteria: they turn sulfate into sulfide, often in the well or the water heater.

A sulfate result is not a hydrogen sulfide measurement. Ask the lab exactly what was tested. (Health Canada spells it "sulphide"; both spellings refer to the same compound.)

Hot water only, or cold water too?

Run the cold and hot water at a few taps and compare.

The smell is in the cold water

The gas is most likely coming from the well. It has to be measured on site, because it escapes quickly from a sample, and treated where water enters the house.

The smell is only in the hot water

According to the Water Quality Association (WQA), the usual cause is a harmless bacterium growing in the water heater and reacting with the magnesium anode. It's worst first thing in the morning. Diagnosis and any change to the water heater (anode, temperature) should be done by a qualified professional. See water heaters, stagnation and microbiological risks.

More than a bad smell

Hydrogen sulfide tarnishes silver and copper, stains fixtures and corrodes some metals. It also interferes with other treatment: it can foul softener and filter media, and it must be treated before a UV system.

How sulfur water is treated

The WQA groups the options into four families, chosen by concentration, pH, and whether iron and manganese are present:

MethodHow it worksWhen it fits
Aeration + filtrationGas is released to air, then filteredModerate to high levels
Chemical oxidation + filtrationChlorine or peroxide oxidizes the sulfideHigh levels, often with iron
Catalytic oxidation filterCatalytic media oxidizes and trapsIron, manganese and sulfur together
Catalytic carbonAdsorption and reaction on carbonLow levels, residual odour

Iron, manganese and hydrogen sulfide (the "troublesome trio") are often treated together: see iron and manganese filters.

Health Canada reference value

Health Canada's aesthetic objective: hydrogen sulfide ≤ 0.05 mg/L (50 µg/L), based on taste and odour. It is not a health-based limit.

Frequently asked questions

Is rotten-egg smelling water dangerous?

Health Canada's objective is aesthetic. The smell says nothing about bacteria or other contaminants, so a well still needs regular lab testing.

Why is the sulfur smell worse in the morning?

Water sits overnight in the water heater and pipes; the gas builds up and is released at the first draw.

Will a water softener get rid of the sulfur smell?

Not reliably. A softener targets hardness; hydrogen sulfide usually needs an oxidation process or catalytic carbon.

Can I just shock chlorinate the well?

Shock chlorination can temporarily reduce sulfur bacteria in a well, but if hydrogen sulfide is naturally present in the groundwater, the smell comes back. Continuous treatment is the lasting fix.

Connect the result to the right treatment

Sources and references
  1. Guidelines for Canadian Drinking Water Quality: Operational Parameters · Health Canada
  2. Guidelines for Canadian Drinking Water Quality: Summary Tables · Health Canada
  3. Bad Taste & Smell · Water Quality Association
  4. Staining · Water Quality Association
It starts with your water

Let’s get a clearer picture.
Together.