Skip to Content
Skip to content
EUREk · Your local water expert in OutaouaisAuthorized, Independent Kinetico Dealer819 303-0838

EUREk · Understanding your water

Maintaining plumbed-in drinking water dispensers

A plumbed-in dispenser combines a filter, sometimes a UV lamp, and a cold or hot reservoir. Maintenance covers both: change filters per the manufacturer, sanitize the reservoir and lines, and clean the spouts and drip tray everyone touches.

Updated October 12, 2026

Routine maintenance

PartUsual interval
Spouts, buttons, drip trayWeekly
FiltersBy volume or about twice a year
Reservoir and linesSanitized at each filter change
Built-in UV lampPer the manufacturer

After a closure or holidays

Standing water needs flushing: run each spout for a few minutes. After a long closure, sanitizing is the better choice.

Information for users

A label with the last service date reassures staff and customers and flags the next visit.

Frequently asked questions

The water tastes off: why?

The filter is often worn out, or the water sat too long. Run the water and check the filter date.

Can a plumbed-in cooler replace bottles?

Yes, with regular service: no more carrying or storing bottles.

Who should sanitize the reservoir?

A technician, with the manufacturer-approved product. Outside surfaces are cleaned on site every week.

Sources and references
  1. Drinking water and health: Treatment · Health Canada
  2. Standards for Water Treatment Systems · NSF
  3. Bacteria & Virus · Water Quality Association

Plan dispenser maintenance

Provide the model, typical use, connected filtration and closure periods.

Request dispenser service