Skip to Content
Skip to content
EUREk · Your local water expert in OutaouaisAuthorized, Independent Kinetico Dealer819 303-0838

EUREk · Understanding your water

Reverse osmosis recovery, reject water and reduction rates

A reverse osmosis system produces two streams: treated water and a concentrate that carries rejected salts to drain. Two figures describe performance. Recovery is the share of incoming water that becomes treated water. Reduction rate is the share of dissolved solids the membrane holds back.

Updated October 12, 2026

What affects performance

FactorEffect
Water pressureMore pressure, more output and better quality
TemperatureCold water slows production
Incoming TDSHighly mineralized water lowers output
Full tankBack-pressure slows the membrane

Reading the performance data sheet

NSF/ANSI 58 certification measures output and reduction under standard conditions. At home, your water pressure and temperature shift those results.

Improving efficiency

A booster pump, a permeate pump or a high-efficiency model reduces the water sent to drain.

Checking quality

Comparing TDS before and after the system gives the real reduction rate. A lasting drop signals a membrane due for replacement.

Frequently asked questions

Where does reject water go?

To drain, through an air-gap connection that protects against backflow. See installation requirements and backflow protection.

Is reject water fine for a septic system?

It holds the same minerals already in the water, more concentrated. For an under-sink system the volume stays modest.

Can recovery be pushed to the maximum?

Excessive recovery concentrates salts on the membrane. The manufacturer sets the safe range for your water.

Sources and references
  1. Standards for water treatment systems · NSF
  2. Reverse Osmosis · WQA
  3. Drinking water treatment · Health Canada

Compare the right performance measures

Share product data sheets and your pressure and water-use conditions.

Compare my options