The three most common alarms
| Signal | Likely cause | What to do |
|---|---|---|
| Lamp reminder | Rated life reached, about one year | Replace the lamp, reset the timer |
| Lamp failure | Lamp or ballast fault | Water is untreated: use bottled water |
| Low intensity | Dirty sleeve, cloudy water, aging lamp | Clean the sleeve, check pre-treatment |
Resetting without a new lamp
The lamp timer should only be reset after a replacement. Silencing it without changing the lamp hides a drop in treatment.
Low-intensity alarms
On models with a UV sensor, a coated sleeve or water high in iron or hardness lowers the light reading. Cleaning the sleeve and the right pre-treatment often solve it.
After a power outage
Water that flows during an outage isn't treated. When power returns, let the lamp warm up and flush the lines per the manual.
Frequently asked questions
Can I drink the water while the alarm is on?
If the lamp is out or intensity is low, treat the water as untreated until it's fixed. A lamp reminder gives you a few days to plan the replacement.
Why does the alarm return after a lamp change?
The timer wasn't reset, the sleeve is dirty or the incoming water changed. Pre-treatment should be checked.
How do I stop the beeping?
Use the silence button in the manual: it mutes the sound, not the cause. The indicator stays on until the problem is fixed.
Sources and references
- Drinking water and health: Treatment · Health Canada
- Treat your well water · Health Canada
- Bacteria & Virus · Water Quality Association